The rivets of the front fender were rotten out. Did put in some fresh steel. Back fender is shortened and the end lip is welded back on for the 'from factory look'. Made a new license plate holder with round LED tail light. The rear shocks are 20mm shorter as the original ones for nice line between fender and wheel. Pedals are removed and replaced by steps. Lowered handle bar. 3d printed tacho/rpm holder. Headlight brackets are also 3d printed but should be a little shorter. Also LED light bulb in the front. Also made a full bridge rectifier for the LED setup. I put this behind the right side cover of the swing arm. Also mounted a side stand.
0 COMMENTSSign in or Create an Account to post a comment.