0.5 Inch Hammer

By Gregory Brettin · Yamaha QT50 · 1986

Added · Updated

1 / 5
My QT50 is a work in progress. My hopes is to make a unique noped. ... We'll see how it goes... Malossi 70 CC kit - Puch High compression head - Nachi Bearings - .04mm Boysen Carbon Fiber Reed - VM18 Carb - KandN Filter - Polini Head Screws - Polished Allen Bolts - PW50 Final Drive Gear - MLM "Peoples" Pipe - Polished Internals - 40lb Clutch Springs - Black Dragon hi performance PW50 ignition kit -

Parts

engine

exhaust

electrical

  • Black Dragon PW50 Performance Kit

carburetion

Comments (3)

Ben LaPlante — 11 years, 7 months ago

I'm finishing a QT50 build currently. That ignition system intrigues me. Does it have an ignition curve?

Gregory Brettin — 12 years, 4 months ago

It's still in the works but I was able to get it out once before I started in on my major mods. The speedo needle was reading in thousands place where the odometer is.

Charlie Maynard — 12 years, 5 months ago

This bike is so rad. Motivation for my Champ for sure! How fast is it on top end?